How
to
Make
a
Bead
To dispense a continuous bead of fluid instead of a single dot, follow these steps.
1Switch the AUTO/MANUAL switch to
MANUAL.
2Set the shot size to the lowest setting.
3For best results, set the dispense rate to slow, to minimize backpressure in the syringe.
4As a beginning point, set drawback to 5 steps
5Keep delay set to zero, then adjust as needed to eliminate any post dispense ooze.
•Press and hold the foot pedal until the required amount is dispensed.
Extend Auto Foot
Retract Manual Hand
1
.00261 cc
2
.065 cc/sec
.065 - 1.567
3
5STEPS
0 - 500
4
0seconds
.00 - 10.00
5
17
