Flowtron Outdoor Products LE-800B Assembly Continued, Assemble Upper and Lower Housing

ASSEMBLY CONTINUED

1. Assemble Upper and Lower Housing

Install the three Tinnerman Clips onto the edge of the Lower Housing in areas provided. Place both Upper Housing and Lower Housing upside down and align the slot in the edge of the Upper Housing with the tab on the Lower Housing.

Push the Lower Housing down until it is seated firmly in the Upper Housing. Position the assembly in the upright position and fasten both housings together using the three #10 x 5/8” sheet metal screws as shown in Figure #5.

Tinnerman Clip (three places)

FIGURE 5

3. Assemble Funnel

Assemble funnel with tabs on outside and screw together in two places using 10-32 x 3/8” screws and 10-32 hex nuts. Place screw heads on inside with nuts on outside.

4. Attach Funnel to Upper Housing

Align four (4) holes in Funnel with four holes in Housing and fasten securely using four #10 x 1/2” screws and #10 flat washer as shown in cutaway view in figure 7.

#10 x 1/2" Screw and

#10 Flat Washer

FIGURE 7

FIGURE 6

page 5