Fluke 123, 124 Displaying an Unknown Signal with Connect-and View, Screen After an Auto Set

Using The Test Tool	1
Displaying an Unknown Signal with Connect-and View™

Displaying an Unknown Signal with

Connect-and View™

The Connect-and-View™ function enables hands-off operation to display complex unknown signals. This function optimizes the position, range, time base, and triggering and assures a stable display on nearly all waveforms. If the signal changes, the setup will track these changes.

To enable the Connect-and-View™ function, do the following:

•Connect the red test lead from red input A to the unknown signal to be measured .

	Perform an Auto Set.
In the next example, the screen displays “1.411” in large		Figure 1-6. The Screen After an Auto Set
numbers and “-0.103” in smaller numbers. A scope trace
gives a graphical representation of the waveform.

The trace identifier (A) is visible on left of the waveform area. The zero icon (-) identifies the ground level of the waveform.

13