Fluke 724 user manual Storing and Recalling Setups, Auto Ramping the Output

Temperature Calibrator

Storing and Recalling Setups

Auto Ramping the Output

Auto ramping gives you the ability to continuously apply a varying stimulus from the calibrator to a transmitter, while your hands remain free to test the response of the transmitter.

When you press L, the calibrator produces a continuously repeating 0 % - 100 % - 0 % ramp in your choice of three ramp waveforms:

•E 0 % - 100 % - 0 % 40-second smooth ramp

•P 0 % - 100 % - 0 % 15-second smooth ramp

•N 0 % - 100 % - 0 % Stair-step ramp in 25 % steps, pausing 5 seconds at each step.

To exit ramping, press any button.

Storing and Recalling Setups

You can store up to eight of your settings in a nonvolatile memory and recall the settings for later use. A low battery condition or a battery change does not jeopardize the stored settings. Proceed as follows:

1.After you create a calibrator setup, press S. In the display, the memory locations appear.

2.Press Yor Zto select locations one through eight. An underscore appears below the selected memory location.

3.Press S. Only the stored memory location will be displayed. The setup is stored.

To recall setups, proceed as follows.

1.Press Q. The memory locations appear on the display.

2.Press Yor Zto select the appropriate location and press Q.

31