CAUTION:Take care that all sensors used as references or being cali-
brated in the furnace are capable of withstanding the desired temperature
range to be used.
WARNING: Take extreme care in handling hot probes. The ex-
treme temperatures generated in a furnace of this type can cause serious
personal injury. Do not touch them on external surfaces of the furnace or
set them on any other surfaces unable to withstand those temperatures. A
fire hazard exists. Do not touch the access tube end plate or severe burns
can result.
Some kind of metaland/or ceramic fiber surface or container should be used to
set the hot probes on to preventinjury, damage, and fire.
Forbest results, all reference or sample probes should be inserted into the full
depth of the well. At this position the stability is the highest and the gradient
the lowest.Each user should satisfy themselves as to what the uncertainties are
in terms of stability and gradients between the test wells. Variationsin equip-
ment, probe size,configuration, etc affect these important factors. A solid
(unstirred)mass such as in a furnace issubject to heat losses from the probe
stem whichvaries from probe to probe and temperature to temperature. Typi-
cally,stabilities are less than ±0.1°C and can be as little as ±0.015°C at 500°C.
Similarly,gradients between the measuring cells can range from ±0.2°C to well
under ±0.1°C. Forcalibrations that must be less than full insertion into the test
well, makeyour own comparisons between the reference and test cell at that
depth to establish the uncertainties.
The furnace can be used throughout the temperaturerange of 300 to 1100°C.
Lowertemperatures are sluggish however. High integrating values are required
to maintain controller stability (1200 sec) at the lowertemperatures. Expect
some offsetfrom the in dicated temperature and the actual temperature. Stability
and gradients between test wells are similar at higher temperatures but time to
stability is much longer.
9112A Calibration Furnace
User’s Guide
24