Fluke 960PS-210, 960PS-200 manual Introduction, General Description, Application, Specifications

Introduction

General Description 1

Section 1

Introduction

1.1 General Description

The 960PS Power Supply is used to supply power to the modules that are plugged into the 960MB/961MB motherboards.

The power supply is mounted outside of the 960CC Card Cage Module, the wall mounted Local Control Unit enclosure, or control room cabinet. The input AC voltage is soft started to inhibit current surges when powered up. EMI protection is also provided as part of the AC voltage protection. The power supply has remote error sensing and short circuit/overload protection along with input and output over-voltage protection. See Figure 1-1, the Power Supply Functional Block Diagram.

1.2 Application

The 960PS-200 & 960PS-210 Power Supply Modules are used in VICTOREEN series area monitors, process monitors, isolators, control rooms, and safety-related display cabinets.

1.3 Specifications

General specifications for the power supply are listed below.

	960PS-200	960PS-210
Dimensions (W x H x D)	4.2 x 2.25 x 6.66 in	5.0 x 2.5 x 10.5 in
Operating Temperature	0° to 50°C, Full Rated	0° to 50°C, Full Rated
Relative Humidity	95% Non-Condensing	95% Non-Condensing
Input Voltage	115 VAC ± 15%	90 - 132 VAC/180 - 240 VAC
	(jumper
	60 Hz ± 5%	selectable) 47 - 440 Hz
Input Power	155 watts	130 watts
Efficiency	71%	75% Minimum
Input Filtering	Common Mode	Common Mode and Differential
Mode
Output Voltages	+5 VDC ± 0.2% @ 10 Amps	+5 VDC ± 0.2% @ 15 Amps
	+15 VDC ± 5% @ 2 Amps	(10% load required for regulation)
	-15 VDC ± 5% @ 2 Amps	+15 VDC ± 2% @ 3 Amps
		-15 VDC ± 2% @ 2 Amps
		+24 VDC ± 1.5% @ 2 Amps
Remote Error Sensing	+5 VDC Sense Provided	+5 VDC Sense Provided
Fault Protection	Short circuit protected by current	Short circuit protected by current
	foldback with automatic recovery	foldback with automatic recovery
Line Voltage Monitor	Not Provided	Factory Set to 90 VAC

1-1