Cutting Head
To replace nylon line.
For your convenience it is recommended you buy spool and line complete. Nylon line only is also available. Both are available from Husqvarna Outdoor Products stockists.
To fit spool and line complete:
1.Remove the Cap (Q1) and Spool Holder (Q2)
2.Remove old spool.(R)
3.Place new spool into spoolholder.(R)
4.Release one line from cleat (W).
5.Secure line into eyelet (S1).
6.Repeat for second line.
7.Refit the Spoolholder and fit the Cap ensuring
it is secure.
To fit nylon line only:
•Remember! Your Flymo Trimmer is designed
to use only nylon line with a maximum diam- eter of 2mm. Use only genuine Flymo nylon line.
1.Take approximately 7 metres of line. Place the
centre of the line into the slot in the middle of the spool (T1) enabling 3.5 metres of line to be wound on either side of the centre section of the spool. Always wind line in the direction of the arrows on the top of the spool. Leave
approximately 100mm of line unwound and place into cleat as illustrated in figure V.
2.Care should be taken to ensure that the line is neatly coiled on the spool. Failure to do so will impair the efficiency of the automatic line feed.
3.Then fit spool as described in ‘To fit spool and line complete’, section above.
Q |
|
| 2 |
| 1 |
R | Cap |
| |
Spool |
|
Eyelet | Eyelet |
| |
Spoolholder |
|
S | S1 |
T |
3.5 metres |
1 |
3.5 metres |
V
Cleat
