Flymo CT250 Assembly Instructions cont’, Fitting the Wall Bracket and Charging the Battery, bolt

3
		Assembly Instructions cont’
B	C	Fitting the Handle (D & E)
		1.	Insert the nut into the handle knob. (if applicable)
		2. Attach steady handle to product using bolt and han-
			dle knob as shown in Fig	D.
		3. Adjust the steady handle to a comfortable operating
			position, see Fig E., by unscrewing the handle knob,
			springing the side lugs apart, moving the handle to
			the required position, carefully re-engaging the teeth
			and then tightening the handle knob.
		Fitting the Shoulder Harness (F)
		1.	Thread the strap through the slot in the battery housing		(F1).
D	E	2. Thread strap through the buckle. Adjust as required to ensure
			the shoulder harness is in the most comfortable position.
nut (if		F
applicable)
			1
handle knob	bolt

Fitting the Wall Bracket and Charging the Battery

G

1

2

•IMPORTANT !

Switch charger off at the wall socket before connecting or disconnecting the trimmer to the wall bracket.

1. It is recommended that the wall bracket	(G2) should be
mounted on a smooth, vertical and internal wall which is
strong enough to hold the weight of the product, in a well
ventilated area between 5°C and 25°C.
2. There are 3 holes on the wall bracket. Position the wall
bracket with the two holes at the top.	See Fig H.
3. Ensure that when the trimmer is attached the bottom of

the trimmer is within 4 inches (100 mm) of the ground, this will make it easier to hang the trimmer and will also ensure that the wall bracket is within easy reach of an electric socket to allow the charger to be plugged in.

4.Fix wall bracket securely to the wall with the plugs and screws provided.

5.Your cordless trimmer can now be attached to the wall

bracket for charging.

Initial Charging Procedure

1.Use the charger indoors only.

2.Ensure the charger is not exposed to moisture. Keep the charger and the trimmer dry at all times. Keep the charger well ventilated during charging.

3.Ensure the trimmer is correctly located into the wall

bracket	(G2) and the charge connector		(H1).
4. Plug the charger		(G1) into a suitable household electrical
wall socket and switch on.

5.The red indicator lamp glows continuously during charging.

6.Full charge will be achieved in 24 hours. During

charging the charger becomes warm. This is normal and means the charger is operating correctly.

Re-Charging Your Cordless Trimmer

H

1

•The battery should be charged for 24 hours before use.

•Re-charge your cordless trimmer immediately after every use for the full 24 hour charging period.

•The cordless trimmer can be left connected to the charger permanently, with the charger switched on, without fear of overcharging.

1.Re-charge the battery as soon as the cutting power of your cordless trimmer begins to die and slow down.

2.Avoid running the cordless trimmer into "deep" dis- charge, i.e. avoid flattening the battery completely.

3. Follow the procedure outlined in the	Initial Charging
Procedure.

4.Charging the battery according to these instructions should ensure maximum battery life.

•The charger will automatically keep the battery topped up with charge during storage and will ensure that the cordless trimmer is ready for use.