5
Fault Finding Chart
WARNING Avoid accidental starting, keep hands and fingers away from the switch lever whilst attempting any maintenance or adjustment.
FAULT
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CHECK
Is the automatic line feed working?
Is the line fed out and visible?
Is the manual line feed work- ing?
|
| ACTION |
|
|
|
|
| Manually feed out line. |
No |
| |
| SEE “MANUAL LINE FEED” | |
|
|
|
|
|
|
|
| Remove cap and spool, free line |
|
| and |
No |
| |
| SEE “SPOOL CAP AND | |
|
| NYLON LINE” |
|
| The line may be jammed on the | |
No |
| ||
| spool. | Rewind line to remove | |
| |||
|
| crossed | loops. |
CONTINUOUS CLATTER-
ING NOISE
LINE SNAPS CONTINU-
OUSLY
Has the motor reached full speed before use?
Has too much line been fed out?
Is the line cutter missing from the safety guard?
Are you using the trimmer correctly?
Is the line jamming on the spool?
|
| Allow the motor to reach full |
No |
| |
| speed before use | |
|
|
|
|
|
|
|
| SEE “MANUAL LINE FEED” |
Yes |
| |
| ||
|
|
|
|
|
|
|
| Contact your local approved |
|
| Service Centre or Electrolux |
Yes |
| |
| ||
|
| Outdoor Products Customer |
|
| |
|
| Service. |
|
|
|
? |
| Only use tip of nylon line to trim. |
| SEE “How to trim and edge” | |
|
|
|
|
|
|
|
| Rewind the line on the spool, if |
Yes |
| symptoms still persist, change |
| ||
|
| spool and line. |
|
|
|
IF NONE OF THE ABOVE OR IF FAULT PERSISTS
Contact Electrolux Outdoor Products Customer Service Telephone : 01325 300303
Manual line feed
U
To manually feed the nylon line
If required, line can be fed out manually. To operate, gen- tly pull on the line whilst at the same time alternately pressing and releasing the button, on the side of the
spoolholder. See fig U.
Do not depress the button more than three times. Excessive line will snag the line cutter and cause the trimmer to malfunction.
Spool cap and nylon line
V | cap |
release | |
| latch |
| cap |
| release |
| latch |
W |
|
cap |
|
spoolholder | spool |
| |
| eyelet |
manual line |
|
feed button |
|
To remove spool cap |
| |
1. | Press and hold in the two cap release latches. | See Fig V. |
2. | Pull cap away from the cutting head. | See Fig W. |
When refitting the spool cap
1.Keep all areas of the cap and spoolholder clean. Failure to do so may prevent the cap being securely located in the spoolholder.
2.Align the two latches on the cap with the two windows in the spoolholder, then press down into the locked position.
3.Ensure the two cap release latches are clearly visible and are fully engaged with the windows in the spool- holder.
4.Check that the cap is correctly fitted by trying to remove it without depressing the two latches.