6
Spool cap and nylon line cont’
To replace nylon line. Replacement nylon line is avail- able from most Electrolux Outdoor Products stockists.
You can buy it either as spool and line complete, or as nylon line only.
To replace spool and line (complete)
1. Unwind approximately 100mm of line and feed this
through eyelet, see fig X, then drop the spool into
spoolholder smooth side uppermost.
To replace nylon line on spool.
1.Take line and insert into hole in spool.
2.Turn spool clockwise to wind on required amount of
line, (approx. half = 10m) and cut line to length, | see | |
fig Y. Care should be taken to ensure that the line is |
| |
neatly coiled on the spool. Failure to do so will impair |
| |
the efficiency of the automatic line feed. |
| |
3. Leave approximately 100mm of line unwound and |
| |
feed this through eyelet, | see fig X, then drop the |
|
spool into the spoolholder | smooth side uppermost. |
•Ensure spool is fully located by gently rotating it during fitment.
•Remember! Your Flymo Cordless Trimmer is designed to use only nylon line with a maximum diameter of 1.5mm. Use only genuine Flymo nylon line.
X
eyelet
Y
line
hole in spool
Caring for your Cordless Trimmer
After you have finished using your Flymo trimmer follow the procedure below:
•Avoid accidental starting. Keep your hands and fingers away from the switch lever while inspect- ing, cleaning or carrying out any maintenance work.
•Keep fingers and hands clear of line cutter on
leading edge of guard.
1.Never clean your trimmer with water, cleaning fluids, or solvents, just remove debris with a suitable tool, a soft brush or dry cloth.
2.Using the scraper provided, clean around the inside of the
safety guard to remove any grass and debris. | (Z1) | |
3. Using a soft brush, clean around the inside of the |
| |
safety guard | (Z2), the cutting head | (Z3) and the motor |
housing. | (Z4) |
|
4.Inspect the trimmer carefully, especially the parts of the cutting head.
5.If your trimmer is damaged in any way contact your local Electrolux Outdoor Products approved service centre.
• Never use a damaged trimmer
6. Store in a cool, dry place and out of reach of children.
Z | 1 | 2 |
| 3 | 4 |
Environmental Information
Electrolux Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life.
•Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.
•Awareness of the environment must be considered when disposing of
•If necessary, contact your local authority for disposal information.
BATTERY DISPOSAL
• The battery should be taken to an Approved Service Centre or your local Recycling Station.
Do NOT dispose of used bat- tery with household waste
Do NOT dispose of battery to water.
Lead/Acid batteries can be harmful and should be disposed of through the recognised recycling facility in accor- dance with European Regulation