Auto Line Feed System
H
line cutter
How the automatic line feed works (H)
1.When initially switching on the trimmer, a small length of line is fed out.
2.A ‘clattering’ noise will be heard when the nylon line hits the line cutter. DO NOT BE ALARMED this is quite normal. After approximately 5 seconds the line will be cut to the correct length and the noise will
reduce as the motor reaches full speed.
•Make sure the motor is up to full speed before trimming or edging.
3.If the noise of the nylon line being cut cannot be heard, more line will need to be fed out.
4.To feed more line, it is first necessary to to allow the motor to stop completely, then
5.Repeat step 4. until you hear the line hitting against the cutter. (Do not repeat this procedure more than 6 times)
6.If problems are experienced with the automatic line feed refer to Fault Finding Chart.
