Flymo Twist n Edge Trimmer Assembly Instructions, Cable Restraint, pivot block, Shaft Assembly A

3

Assembly Instructions

A
	1		2
		1	2
B	2	1	3

4

C

Shaft Assembly (A)
1. Locate the lower shaft	(A1) into the upper
shaft (A2).

2.Grasp firmly and hold steady the lower shaft. Locate the upper shaft and snap together

firmly.

•The unit is correctly assembled when the gap between the upper and lower shaft has been closed.

Safety Guard Assembly (B) & (C)

1.Align the arrow on the top of the safety guard

(B1) with the arrow on the side of the trimmer

(B2).

2. Locate the safety guard		(B3) over the cutting
head	(B4). Ensure the	nylon lines are fed
through the hole in the safety guard as illus-
trated in	fig B.

3.Push into location and turn safety guard in

the direction illustrated in Fig C, until a click is heard and the safety guard is securely

locked in position.

•ENSURE THE SAFETY GUARD IS SECURELY IN PLACE BY ATTEMPTING TO TWIST GUARD IN OPPOSITE DIREC- TION.

D

E		Steady Handle Assembly (D) & (E)
		1.	Place bolt through hole in underside of steady
	pivot block		handle	(figure D).
		2.	Push bolt through holes in pivot block		(Figure E).
		3. Insert nut into handle knob (if applicable)
		4.	Hold bolt in position with finger then fit wash-
			er and handle knob. Tighten handle knob (do
			not overtighten).
		•	To adjust steady handle to new position,
			loosen handle knob and move handle to most
			comfortable operating position. Re-tighten
			handle knob.

Cable Restraint

F

G

Cable Restraint (F) & (G)

1.Form loop in mains cable and push the loop

through the slot as illustrated in picture (F).

2.To secure, position loop over the hook and pull the cable back through the slot as illus-

trated in picture (G).