www.fmiproducts.com
121353-01H 17
INSTALLATION
Continued
as illustrated in gure 20.
4. Make sure open areas of logs line up
with burner ports (see gure 21). Logs
will t securely on chassis. IMPORTANT:
Make sure log does not cover any burner
ports.
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no ame
comes in contact with any log.
With the heater set to High, check
to see if ames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
NOTE: Log sets may come with either ber
pegs or metal pins. The following instructions
can be followed for either design.
1. Place front log (#1) and rear log (#2) on
grate to t as illustrated in Figure 18.
2. Place center insert log (#3) as illustrated
in Figure 19. Log should rest on burner
and burner bracket. Do not block burner
ports
3. Place top log (#4) and top right log (#5)
Figure 19 - Installing Center Insert Log (#3)
Logs
Burner Ports
Figure 20 - Installing Top Left Log(#4)
and Top Right Log (#5)
Figure 18 - Installing Front (#1) and Rear
(#2) Logs
Top Left
Log (#4)
Figure 21 - Installing Log Set (Top View)
Center Insert
Log (#3)
Peg
Top Right
Log (#5)
Be sure that pegs
go into hole with
same shape
(round vs. square)
Rear Log (#2)
Burner
Chassis
Grate
Burner
Port
Front
Log (#1)
Be sure that
pegs go into
hole with
same shape
(round vs.
square)