Warning: Electrostatic discharge (ESD) damage can occur when components are mishandled. Always wear an
Caution: Unlock the levers before inserting the line card into the chassis. Fully engage the locking mechanism once the card has been inserted; not doing so will cause damage to the card below when that card is inserted.
Step Task
1Extend the left and right card levers by first pressing gently down on the thumb tabs (see Figure 2) in the ejector levers and then pulling the ejector levers simultaneously until they are in the open position. See Figure 3.
Figure 2 Depress the thumb tabs
Figure 3 Extend the levers
2Hold the card assembly by the metal carrier edges. Avoid touching the printed circuit board and connector pins.
3Align the card with the guide, and gently slide it into any line card slot until the card is about halfway into the slot.
Installation Notes: Use the markings on the fan tray to determine which slots are for the RPMs and which are for the line cards.
3 |
