F | ASSEMBLY | ASSEMBLYVEHICLE CARE | GF |
|
|
|
|
Pretend
Engine
30 |
Hint: Before assembling the pretend engine, you may want to install the battery. Please refer to page 20, steps 1 and 2.
•Fit the pretend engine into the front end of the vehicle.
•Insert two 1" bolts into the pretend engine.
•Tighten the screws.
Hood Peg
•Check all screws, cap nuts and their protective coverings regularly and tighten as required. Check plastic parts on a regular basis for cracks or broken pieces.
•During snowy or rainy weather, the vehicle should be stored inside or under a protective cover. Remember to charge the battery at least once per month while your vehicle is not in regular use.
•Avoid operating the vehicle in wet or snowy conditions, and do not spray the vehicle with a hose. Do not wash the vehicle with soap and water. Water or moisture in the motors or electrical switches can cause them to corrode, and could cause switch or motor failure.
•Avoid operating the vehicle on sand, loose dirt or gravel. Sand, loose dirt or gravel in the motors or electrical switches can cause them to jam, and could cause switch or motor failure.
•The vehicle can be wiped down with a soft, dry cloth. For a shiny finish, you can wipe plastic parts with a
•To ensure that your vehicle stays in good operating order, we recommend that you periodically have your vehicle checked by a Power Wheels® authorized service center. For the location of the authorized service center nearest you, please visit us
Slot
31 |
•Fit a peg on the hood into a slot in the front end of the vehicle.
•Flex the hood slightly and then insert the other hood peg into the other slot in the front end of the vehicle.
•Lower the hood. Push down near the front of the hood to “snap” into place.
17 | |
|
|
