E | BATTERY CHARGING |
| ASSEMBLY | F |
|
|
|
|
|
| B |
Battery |
|
Connector |
|
A | Charger |
Connector | |
GAP | NO GAP |
INCORRECT | CORRECT |
•Plug the charger connector into the battery connector A . Push firmly to make sure the connectors are completely joined.
•Plug the charger into a standard wall outlet B .
Notes:
-Use the charger only in a wall outlet. Do not plug the AC adaptor into a ceiling outlet.
-If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.
•Before
•Recharge the battery for at least 14 hours after each use of your vehicle. Do not charge the battery longer than 30 hours.
•Once the battery is charged, disconnect the battery connector from the charger connector. Unplug the charger from the wall outlet. The battery is now ready to be installed in your vehicle. Please see the Battery Installation section on page 20 for detailed instructions on installing your battery. If your battery is already installed in your vehicle, simply
WARNING
Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help in assembly of the vehicle.
.437"
Rear Axle
.437 Cap Nut
1 |
•Place a .437 cap nut on a flat surface, inside up.
•Fit the end of the rear axle into the cap nut.
•Tap the opposite end of the rear axle with a hammer to secure the cap nut on the rear axle. Pull on the cap nut to be sure it’s secure.
9 | |
|
|
