Franke Consumer Products FDMO 607 I manual Fitting the Chimney and Fixing the Hood Canopy

Fitting the Chimney and Fixing the Hood Canopy

12c

• Insert the Top chimney with the slots facing upwards when installing the recirculation version, or vice versa with the slots facing downwards when installing the ducting version, then fix the top part to the Upper Chimney Connector using the screws 12c (2.9 x 9.5) provided.

Recirculation version

•	Make sure that the Air Outlet Connector 15 is positioned in
	correspondence with the Chimney Grill.
•	If this is not the case, remove the chimney and adjust the posi-
	tion of the Air Outlet Connector 15; replace the components as
	described above.	12f

Before fixing the Hood Canopy to the Frame:

•Remove the metal grease filters from the hood canopy.

•Remove any activated charcoal odour filters.

•Fix the hood canopy to the frame provided, working from be- low and using the 4 screws 12f supplied.

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-pole switch hav- ing a contact gap of at least 3 mm.

• Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan.

•Join the connectors.

•Install the odour filter and the charcoal filter in case the hood is to be used in recycling version.

•Install the grease filter again.

EN	1
	13