Franke Consumer Products FDS 307 W Charcoal filter ductless version, Lighting, Light Replacement

Charcoal filter (ductless version)

•This filter cannot be washed or regenerated. It must be replaced when the EF appears on the display or at least once every 4 months.

Activation of the alarm signal

•In the recycling version hoods the filter saturation alarm must be activated during the instal- lation or later.

•Switch off the hood and the lights.

•Disconnect the hood from the main voltage supply.

•After restoring the connection press and hold B-key.

•When releasing the key two rotating rectangles appear on the display.

•Within 3 seconds press the B-key until a flashing confirmation appears on the dispaly:

•2 flashes with EF - charcoal filter saturation alarm ACTIVATED

•1 flash with EF - charcoal filter saturation alarm DEACTIVATED.

REPLACING THE CHARCOAL FILTER
Reset of the alarm signal
•	Switch off the hood and the lighting. If the 24h-function has	B	A
	been activated this has to be deactivated.
•	Press the E-key until the display is unlit.

Replacing of the filter

•Remove the metal grease filters

•Remove the saturated activated charcoal filter as shown (A).

•Fit the new filters (B).

•Replace the metal grease filters.

Lighting

LIGHT REPLACEMENT

20 W halogen light.

• Remove the snap-on lamp cover by levering it from under the metal ring, supporting it with one hand.

•Remove the halogen lamp from the lamp holder by pulling gently.

•Replace the lamp with a new one of the same type, making sure that you insert the two pins properly into the housings on the lamp holder.

•Replace the snap-on lamp cover.

EN	1
	13