How to operate your Friedrich
2 6
5
3 | 5 | 4 | 1 |
Power
Temp
Fan Speed
Timer Mode
1
2
4
3
Control and Remote Control Operations
1.POWER
Operation begins when this button is pressed and stops when you press the button again.
2.TEMPERATURE CONTROL
The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 60°F~86°F (16°C~30°C).
The unit takes an average of 30 minutes to adjust the room temperature by 1°F.
3.OPERATION MODE SELECTOR Select cooling mode to cool the room. Select Money Saver® mode for energy saving operation.
Select fan mode for basic ventilating fan operation.
Select dry mode for dry operation.
4.FAN SPEED SELECTOR
For increased power while cooling, select a higher fan speed.
3 steps: High; Low; Med
5.ON/OFF TIMER
The timer can be set to start and stop the unit in hourly increments (up to 12 hours).
6.REMOTE CONTROL SENSOR
Inserting the Remote Control Batteries
1.Push out the cover on the back of the remote control with your thumb
2.Pay attention to polarity and insert two new AAA 1.5V batteries.
3.Reattach the cover.
NOTE: Do not use rechargeable batteries. Make sure that both batteries are new.
• In order to prevent discharge, remove the batteries from the remote control if the air conditioner is not going to be used for an extended period of time
Keep the remote control away from extremely hot or
humid places.
To maintain optimal operation of the remote control, the remote sensor should not be exposed to direct sunlight.
•The remote control can be mounted on a wall using the mountable holder.(Friedrich does not provide this.)
5
