SLEEP TIMER OPERATION
Unlike other timer functions, the SLEEP timer is used to set the length of time until air conditioner operate is stopped.
To Use the SLEEP Timer
While the air conditioner is operating or stopped, press the SLEEP button (Fig. 6 I).
The indoor unit’s OPERATION Indicator Lamp (red) (Fig. 3 5) lights and the TIMER Indicator Lamp (green) (Fig. 3 6) light.
To Change the Timer Settings
To Cancel the Timer:
Use the TIMER MODE button to select “CAN- CEL”.
The air conditioner will return to normal opera- tion.
To Stop the Air Conditioner During Timer Operation:
Press the START/STOP button.
Press the SLEEP button (Fig. 6 I) once again and set the time using the TIMER SET ( 
/ 
) buttons (Fig. 6 N).
Set the time while the Timer Mode Display is flashing (the flashing will continue about five seconds).
button: Press to advance the time. 
button: Press to reverse the time.
About five seconds later, the entire display will reappear.
About the SLEEP Timer
To prevent excessive cooling during sleep, the SLEEP timer function automatically modifies the thermostat setting in accordance with the set time setting. When the set time has elapsed, the air conditioner completely stops.
During Cooling/Dry operation:
When the SLEEP timer is set, the thermostat setting is automati- cally raised 2 °F every sixty minutes. When the thermostat has been raised a total of 4 °F, the thermostat setting at that time is maintained until the set time has elapsed, at which time the air conditioner automatically turns off.
SLEEP timer setting
Set time
1 hour |
|
2 °F | 4 °F |
|
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2) on the main unit control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2 2) once again. (Controls are located inside the Open Panel)
●When the air conditioner is operated with the controls on the Main Unit, it will oper- ate under the same mode as the AUTO mode selected on the Remote Controller (see page 7).
●The fan speed selected will be “AUTO” and the thermostat setting will be stand- ard.(76°F)
En-9
9315345394_OM.indb 9
9/30/2010 2:44:24 PM
