OPERATION
To Select Mode Operation
1 Press the START/STOP button (Fig.6 P).
The indoor unit’s OPERATION Indicator Lamp (red) (Fig. 3 5) will light. The air conditioner will start operating.
2 Press the MASTER CONTROL button (Fig.6 J) to select the desired mode.
Each time the button is pressed, the mode will change in the following order.
▲AUTO |
| ▲COOL | ▲ DRY | ▲ FAN |
|
About three seconds later, the entire display will reappear.
To Set the Thermostat
Press the SET TEMP. button (Fig. 6 K).
button: Press to raise the thermostat setting. button: Press to lower the thermostat setting.
●Thermostat setting range:
AUTO | |
Cooling/Dry |
The thermostat cannot be used to set room temperature during the FAN mode (the tem- perature will not appear on the Remote Controller’s Display).
About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ some- what from the actual room temperature.
Example: When set to COOL.
Example: When set to 80 °F.
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 6 O).
Each time the button is pressed, the fan speed changes in the following order:
▲
AUTO
▲
HIGH
▲
MED
▲
LOW
▲
QUIET
About three seconds later, the entire display will reappear.
When set to AUTO:
Cooling | : As the room temperature approaches that of the thermostat setting, the fan |
| speed becomes slower. |
Fan | : The fan runs at the MED fan speed. |
SUPER QUIET Operation
When set to Quiet: | Example: When set to AUTO. |
SUPER QUIET Indicator Lamp (orange) (Fig. 3 7) will light.
SUPER QUIET operation begins. The indoor unit’s airflow will be reduced for quieter operation.
●SUPER QUIET operation cannot be used during Dry mode. (The same is true when dry mode is selected during AUTO mode operation.)
●During Super Quiet operation, Cooling performance will be reduced somewhat. If the room does not cool down when using SUPER QUIET Operation, please adjust the air conditioner’s Fan Speed.
En-6
9315345394_OM.indb 6
9/30/2010 2:44:22 PM