TRIM HARNESS TO LENGTH
TO CHASSIS JUNCTION
4.0 IN.
18.0 IN.
EXPOSE
WIRES
(1.0 IN.)
STRIP WIRE ENDS (0.5 IN.)
TO WALL JUNCTION
FRP032
| STRAIGHT | |
| CONNECTOR | |
WALL CONNECTION | JUNCTION | |
| ||
| BOX | |
| GROUND | |
| SCREW | |
GROUND |
| |
WIRE |
| |
HARNESS |
| |
JUNCTION | COVER | |
SCREWS | ||
BOX COVER | ||
| ||
| FRP033 |
| LEADING SIDE FOR |
| WIRE HARNESS INSERTION |
SPACER | LOCKNUT |
| |
| CHASSIS |
| JUNCTION |
SPACER | BOX |
3.Route the cut ends of harness through the conduit connector
assembly and 
conduit sleeve. Be sure to use the supplied conduit bushing to prevent damage to the cord by the conduit.
The cord should pass through the Locknut, Spacer, Chassis Junction Box, Conduit Connector, Bushing, then the Conduit Sleeve. Refer to wire harness insertion diagram.
4.Route the cut ends of the power cord through the elbow connector at the other end of the conduit. Tighten screws on elbow connector to secure conduit sleeve.
5.Fasten and secure the elbow connector to the wall junction box cover with locknut. Place and mount the wall junction box with the four wall mounting screws making sure to pass the wall lines through the junction box. Connect and join all wall lines with the stripped ends using wire nuts. Tighten both screws of the wall junction box cover to junction box.
CONDUIT |
CONNECTOR |
BUSHING
CONDUIT
SLEEVE 
EXITING SIDE FOR
WIRE HARNESS
FRP034
17
