Friedrich ZQ08A10C manual Install the Case in the Window

3.7 INSTALL THE CASE IN THE WINDOW

Step 1. Open the window and mark the centerline of the window stool (or desired air conditioner location).

Step 2. Carefully place the case on the window stool and align the center mark on the bottom front with the centerline of the stool

Step 3. Pull the window down behind the top mounting rail

Top mounting rail

Window Sash Top

Sash	mountaing rail
seal
Cabinet
	Frame curtains
Window stool

Front angle

NOTE: Do not shut the window so tightly that movement of the frame curtains is restricted.

Step 4. Loosely assemble the sill supports.

Step 5. Select the position that will place the sill supports near the outermost point on the sill. Attach the sill supports to the case track hole in relation to the selected position using 2 type A screws in each support.

Step 6. Adjust the bolt and the nut in each support so that the case is installed with a slight downward tilt (about 1/2").

Step 7. Secure the case to the window stool by using 3 type B screws.

INDOOR

Bolt

Frame guide

INDOOR

Sill Support

OUTDOOR

Sill Support

Nut

Screw(Type A)

ABOUT 1/2"

Cabinet

OUTDOOR

Sash

Track

Front Angle

Screw(Type B)

Step 8. Pull the frame curtains to each window sash track. Attach them on each side to the window sash and the window stool using 4 type C screws.

3.8INSTALL THE WINDOW LOCKING BRACKET AND THE FOAM TOP WINDOW GASKET

Step 1. Attach the window locking bracket with type C screw.

Step 2. Cut the foam top window gasket to the window width.

Step 3. Stuff the foam between the glass and the window to prevent air and insects from getting into the room.

Screw

(Type C)

Screw

(Type C)

Foam top window gasket

— 15—