Friedrich ZQ08A10C manual Contents, Preface

CONTENTS

1. PREFACE
1.1 SAFETY PRECAUTIONS	2
1.2 INSULATION RESISTANCE TEST	2
1.3 SPECIFICATIONS	3
1.4 FEATURES	4
1.5 CONTROL LOCATIONS	4
2. DISASSEMBLY INSTRUCTIONS
2.1 MECHANICAL PARTS	5
2.1.1 FRONT GRILLE	5
2.1.2 CABINET	5
2.1.3 CONTROL BOX	5
2.2 AIR HANDLING PARTS	6
2.2.1 AIR GUIDE AND BLOWER	6
2.2.2 FAN AND SHROUD	6
2.3 ELECTRICAL PARTS	7
2.3.1 OVERLOAD PROTECTOR	7
2.3.2 COMPRESSOR	7
2.3.3 CAPACITOR	7
2.3.4 POWER CORD	8
2.3.5 THERMOSTAT	8
2.3.6 ROTARY SWITCH	8
2.3.7 MOTOR	8
2.4 REFRIGERATION CYCLE	9
2.4.1 CONDENSER	9
2.4.2 EVAPORATOR	9
2.4.3 CAPILLARY TUBE	9

3. INSTALLATION
3.1 INSTALLATION HARDWARE................................12
3.2 SELECT THE BEST LOCATION ...........................12
3.3 WINDOW REQUIREMENTS .................................13
3.4 STORM WINDOW REQUIREMENTS ...................13
3.5 PREPARING THE UNIT FOR INSTALLATION	14
3.6 BEFORE INSTALLATION	14
3.7 INSTALL THE CASE IN THE WINDOW	15
3.8 INSTALL THE WINDOW LOCKING BRACKET
AND THE FOAM TOP WINDOW GASKET	15
3.9 INSTALL THE AIR CONDITIONER IN THE CASE ...	16
3.10 TO REVERSE THE GRILLE OPENING	16
4. TROUBLESHOOTING GUIDE
4.1 OUTSIDE DIMENSIONS	17
4.2 PIPING SYSTEM	18
4.3 TROUBLESHOOTING GUIDE	19
5. SCHEMATIC DIAGRAM
• CIRCUIT DIAGRAM	24
6. EXPLODED VIEW	25
7. REPLACEMENT PARTS LIST	26

1. PREFACE

This SERVICE MANUAL provides various service information, the mechanical and electrical parts etc. This room air conditioner was manufactured and assembled under a strict quality control system.

The refrigerant is charged at the factory. Be sure to read the safety precautions prior to servicing the unit.

1.1 SAFETY PRECAUTIONS

1.When servicing the unit, set the ROTARY SWITCH or POWER SWITCH to OFF and unplug the power cord.

2.Observe the original lead dress.

If a short circuit is found, replace all parts which have been overheated or damaged by the short circuit.

3.After servicing the unit, make an insulation resis- tance test to protect the customer from being exposed to shock hazards.

—2—

1.2 INSULATION RESISTANCE TEST

1.Unplug the power cord and connect a jumper between 2 pins (black and white).

2.The grounding conductor (green or green & yellow) should be open.

3.Measure the resistance value with an ohm meter between the jumpered lead and each exposed metallic part on the equipment at all the positions (except OFF or O) of the ROTARY SWITCH.

4.The value should be over 1MΩ .