Frigidaire 242288200, FGHC2331PF6, FGHS2655PF, FGHC2331PF0, FGHS2631PF2, FGHS2631PE Plastic Water

CONNECTING THE WATER SUPPLY

5With steel clamp and screw, secure water supply line (copper tubing only) to rear panel of refrigerator as shown.

6Coil excess water supply line (copper tubing only), about 2½ turns, behind refrigerator as shown and arrange coils so they do not vibrate or wear against any other surface.

7Turn ON water supply at shutoff valve and tighten any connections that leak.

8Reconnect refrigerator to electrical power source.

9To turn ice maker on, lower wire signal arm (side mounted) or set the ice maker’s On/Off power switch to the “I” position (rear mounted).

Plastic Water	Steel
Tubing to Ice	Clamp
Maker Fill	Brass
Tube	Compression
	Nut
	Ferrule
	(Sleeve)
	Copper
	water line
	Water Valve
	Bracket
	Valve Inlet
	Water Valve
	Copper water line
	from household
	water supply

(Include enough tubing in loop to allow moving refrigerator out for cleaning.)

Figure 1

Plastic Water Tubing	Steel
to Ice Maker
Fill Tube	Clamp

Stainless

Steel

water line

Water Valve

Bracket

Valve Inlet

Water Valve

6 ft. Stainless Steel water line from household water supply

Figure 2

IMPORTANT

After connecting the water supply, refer to “How to Prime the Water Supply System” for important information about priming an empty water supply system.

Your refrigerator’s water supply system includes several tubing lines, a water filter, a water valve, and a water tank. To ensure that your water dispenser works properly, this system must be completely filled with water when your refrigerator is first connected to the household water supply line.

11