SETTING SURFACE CONTROLS
Dual radiant surface elements (some models) Symbols on the backguard are used to indicate which coil of the dual radiant element will heat. The 
symbol indicates the inner coil only. The 
symbol indicates both inner and outer coils will heat.
To operate a dual radiant element:
1.Place correctly sized cookware on dual radiant surface element.
2.Push in and turn the surface control knob clockwise to begin heating both the inner and outer portions of the dual element. If only the inner heating portion is needed like for smaller cookware, push in and turn the knob
3.When cooking is complete, turn the dual radiant surface element OFF before removing the cookware.
Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. The surface control knobs do not have to be set exactly on a particular mark.
Use the marks as a guide and adjust the control knob as needed. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.
You may switch from either coil setting at any time during cooking. See Suggested radiant surface element settings table on previous page.
Heating with inner (small)
element only
Areas that heat are shown darkened.
Heating with both
elements
Fig. 2
CAUTION
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place flammable items such as plastic salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.
IMPORTANT
Do not allow aluminum foil, or ANY material that can melttomakecontactwiththeceramicglasscooktop. If these items melt on the cooktop they will damage the ceramic cooktop.
NOTES
The size and type of utensil used, and the amount and type of food being cooked will influence the setting needed for best cooking results.
The on indicator light will glow when one or more elements are turned ON. A quick glance at this indicator light when cooking is finished is an easy check to be sure all control knobs are turned OFF. The hot surface indicator light will continue to glow AFTER the control knob is turned to the “OFF” position and will glow until the heating surface area has cooled sufficiently.
10
