Setting Surface Controls
The color of the flame is the key to proper burner adjustment. A good flame is clear, blue and hardly visible in a
Each burner lights automatically from an electric ignitor each time a control knob is turned to the LITE position.
Surface Burner Control |
Knob |
To operate the surface burner: | NOTE: All knobs shown in this | |
1. Place cooking utensil on burner. | ||
owner's Guide are typical only. | ||
|
2.Push in and turn the Surface Control knob counterclockwise to LITE.
3.Visually check that the burner has lit.
4.After the burner ignites, turn the control knob to the desired flame size. The knob can now be turned in either direction without being pushed in. The control knobs do not have to be set at a particular mark. Use the guides and adjust the flame as needed. DO NOT cook with the control knob in the LITE position, as this will cause excess wear on the ignitor electrode.
5.To turn the burner off, turn the control knob clockwise as far as it will go, to the OFF position.
In the event of an electrical power outage, the surface burners can be lit manually. To light a surface burner, hold a lit match to the burner head, then slowly turn the surface control knob to LITE. After the burner ignites, turn the control knob to the desired flame size. Use caution when lighting surface burners manually.
Surface burners in use when an electrical power failure occurs will continue to operate normally.
Do not operate the burner for an extended period of time without cookware on the grate. The finish on the grate may chip without cookware to absorb the heat.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the cooktop when it is in use. These items could melt or ignite. Pot holders, towels or wood spoons could catch fire if placed too close to a flame.
Before Setting Oven Controls
Oven Vent Location
The oven is vented through at the rear of the cooktop. When the oven is on, warm air is released through the vents. This venting is necessary for proper air circulation in the oven and good baking results. DO NOT block the vents. Doing so may cause cooking failures, fire or damage to the appliance
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING
THE OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and slide out.
To replace an oven rack, Fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.
Setting Oven Controls
For oven settings, refer to the Electronic Oven Control Guide.
General 9 information
