Frigidaire ELECTRONIC CONTROL AIR CONDITIONER manual Timer Delay Stop / Start Feature

Air Conditioner Features

(continued)

TO OPERATE ON FAN ONLY: YOU WILL SEE:

DO THIS:

PRESS MODE

BUTTON

CHOOSE FAN

ONLY

LIGHT On

Note: Use this function only when cooling is not desired, such as for room air circulation or to exhaust stale air(on some models). (Remember to open the vent during this function, but keep it closed during cooling for maximum cooling efficiency.) You can choose any fan speed you prefer.

During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode.

TO USE THE ENERGY SAVER FEATURE:

DO THIS:

PRESS MODE

BUTTON

CHOOSE

ENERGY SAVER

YOU WILL SEE:

LIGHT On

Note: In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on and cooling stars.

TIMER: DELAY STOP / START

FEATURE

DO THIS:

PRESS

TIMER BUTTON

YOU WILL SEE: TIMER SETTING

LIGHT On

Note: For Delay Stop, the unit must be in the On position.

Note: For Delay Start, the unit must be in the Off position.

To adjust timer setting, tap or hold the UP arrow( ) or the DOWN

arrow( ) to change delay timer at .5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.). The Delay Start mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same as previously set. To change the set temperature, press “COOL” then Up or Down ar- rows until the desired temperature is indicated on the display. After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Turning the unit “ON” or “OFF” at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens the above steps have to be repeated again.

7

SZ000728(En)-Yaokong 7 09/20/2005, 5:30 PM