Integra DTR-5.6 Common Functions, Adjusting Speaker Levels, Setting the Display Brightness, Notes

DTR-5.6.book Page 52 Thursday, September 22, 2005 5:07 PM

Common Functions

This section explains functions that can be used with any input source.

Press
[Receiver]
first
Dimmer	Sleep
Display	Muting
CH Sel	Level – +

Adjusting Speaker Levels

You can adjust the volume of each speaker while listen- ing to an input source. These temporary adjustments are cancelled when the AV receiver is set to Standby.

1	Use the remote controller’s
	[CH Sel] button to select each
	speaker, and use the [Level–] and
	[Level+] buttons to adjust the vol-
	ume.
	You can adjust the volume of each
	speaker from –12 dB to +12 dB
	(–15 dB to +12 dB for the subwoofer).

Notes:

•You cannot use this function while the AV receiver is muted.

•Speakers that are set to No or None in the Speaker Configuration cannot be adjusted.

■Headphones

While a pair of headphones is connected, you can adjust the volume of each headphone speaker, from –12 dB to +12 dB each.

Phones Dimmer Display

Setting the Display Brightness

You can adjust the brightness of the display.

Remote	Press the [Dimmer] button
controller	repeatedly to select: Normal,
	Dim, Dimmer.
AV receiver

•These settings are stored when the AV receiver is set to Standby.

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.

Press the remote controller’s [Muting] button.

The output is muted and the MUTING indicator flashes on the display.

To unmute the AV receiver, press the remote control- ler’s [Muting] button again, or adjust the volume. The output is unmuted and the MUTING indicator goes off. Muting is cancelled when the AV receiver is set to Standby.

Tip:

You can choose how much the output is muted by using the Muting Level preference (see page 69).

52