Integra DTR-5.6 Remote IDs, Changing the AV Receiver’s Remote ID, times, Advanced Setup—Continued

DTR-5.6.book Page 71 Thursday, September 22, 2005 5:07 PM

Advanced Setup—Continued

Remote IDs

Remote indicator

Number

buttons

Receiver

Enter

TV INPUT

Setup

3	Use the Up and Down [ ]/[ ]
	buttons to select “Remote ID,”
	and use the Left and Right
	[ ]/[ ] buttons to select ID 1, 2,
	or 3.
	8.Hardware Setup
	------------------------
	a.PoweredZone2:NotAct
	b.Zone2 Out :Fixed
	c.TV Format	:Auto
	d.AM Freq. Step: 9kHz
	e.Remote ID	:1
4	Press the [Setup] button.
	Setup closes.

Note:

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons and [Enter] button.

Changing the AV Receiver’s Remote ID

When several Integra components are used in the same room, their remote ID codes may overlap. To differenti- ate the AV receiver from the other components, you can change its remote ID from 1, the default, to 2 or 3.

Note:

If you change the AV receiver’s remote ID, be sure to set the remote controller to the same ID (see next column).

1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.
	The main menu appears onscreen.

2 Use the Up and Down []/[ ] buttons to select “8. Hardware Setup,” and then press [Enter]. The Hardware Setup menu appears.

Changing the Remote Controller’s ID

To differentiate the remote controller from other Integra components, you can change its remote ID so that it matches the AV receiver’s Remote ID setting.

Note:

If you change the remote controller’s remote ID, be sure to set the AV receiver to the same ID. Otherwise, you won’t be able to control it (see previous column).

1		Press and hold down the
		[Receiver] Remote Mode button,
		and then press the TV [Input] but-
		ton.
		The Remote indicator flashes four
		times.
2		Use the number buttons to enter
V1	V2	remote control ID 1, 2, or 3.
		V3
1	2	3 The Remote indicator flashes twice.

71