Integra DTR-5.6 instruction manual Advanced Setup, Speaker Setup, Speaker Configuration

DTR-5.6.book Page 63 Thursday, September 22, 2005 5:07 PM

Advanced Setup

Speaker Setup 2

This section explains how to check the speaker settings and how to set them manually, which is useful if you change a speaker after performing the automatic speaker setup.

Some speaker settings are set automatically by the Auto- matic Speaker Setup function (see page 37).

Use the Up and Down []/[ ] buttons to select “3. Speaker Setup,” and then press [Enter].

The Speaker Setup menu appears.

Receiver

Enter

Speaker Configuration

3

Setup

4

Use the Up and Down []/[ ] buttons to select “Speaker Con- figuration,” and then press [Enter].

The Speaker Config menu appears.

3-2.Speaker Config

------------------------

a.Subwoofer	:Yes
b.Front	:Large
c.Center	:Small
d.Surround	:Small

e.SurroundBack :Small

f.SurrBack Ch	:2ch
g.Crossover	:100Hz

h.Subwoofer Mode :-------------

Use the Up and Down []/[ ] buttons to select “a. Subwoofer,” and then use the Left and Right []/[ ] buttons to select:

This setting is set automatically by the Automatic Speaker Setup function (see page 37).

Here you can specify which speakers are connected and

their individual sizes.		5
For speakers with a cone diameter
over 6-1/2 inches (16 cm), specify
large, and for those with a diameter
below this, specify small.
	Cone diameter
1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.

The main menu appears onscreen.

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

Use the Up and Down []/[ ] buttons to select “b. Front,” and then use the Left and Right

[]/[ ] buttons to select:

Small: Select if the front speakers are small.

Large: Select if the front speakers are large.

Note:

•If the Subwoofer setting in step 4 is set to No, this setting is fixed at Large.

63