Integra DTR-5.6 Remote Controller, Recording, Others, Troubleshooting—Continued, Can’t record

DTR-5.6.book Page 86 Thursday, September 22, 2005 5:07 PM

Troubleshooting—Continued

Remote Controller

The remote controller doesn’t work

•Make sure that the batteries are installed with the cor- rect polarity (page 7).

•Make sure that the remote controller is not too far away from the AV receiver, and that there’s no obstruction between the remote controller and the AV receiver’s remote control sensor (page 7).

•Make sure you’ve selected the correct remote control- ler mode (page 12).

•Make sure you’ve entered the correct remote control code (page 79).

Can’t control other components

•Make sure you’ve selected the correct remote control- ler mode (page 12).

•If you’ve connected an -capable Integra MD recorder, CD recorder, or next generation HDD-com- patible component to the TAPE IN/OUT jacks, or an Onkyo DS-A1 Remote Interactive Dock to the VIDEO 3 IN jacks, for the remote controller to work properly, you must set the input display to MD, CDR, or HDD (see page 42).

•The entered remote control code may not be correct. If more than one code is listed, try each one.

•If none of the codes work, use the Learning function to learn the commands of the other component’s remote controller (page 82).

•With some AV components, certain buttons may not work as expected, and some may not work at all.

•To control an Integra component that’s connected via

, point the remote controller at the AV receiver. Be sure to enter the appropriate remote control code first (page 80).

•To control an Integra component that’s not connected

via , or another manufacturer’s component, point the remote controller at the component. Be sure to enter the appropriate remote control code first (page 79).

Can’t learn commands from another remote controller

•When learning commands, make sure that the trans- mitting ends of both remote controllers are pointing at each other.

•Are you trying to learn from a remote controller that cannot be used for learning? Some commands cannot be learned, especially those that contain several instructions.

Recording

Can’t record

•On your recorder, make sure the correct input is selected.

•To prevent signal loops and damage to the AV receiver, input signals are not fed through to outputs with the same name (e.g., TAPE IN to TAPE OUT, VIDEO 1 IN to VIDEO 1 OUT, or VIDEO 2 IN to VIDEO 2 OUT).

Others

The sound changes when I connect my head- phones

•When a pair of headphones is connected, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, or Direct, in which case it stays the same.

How do I change the language of a multiplex source

•Use the “Multiplex” setting on the “Audio Adjust” menus to select “Main” or “Sub” (page 61).

The functions don’t work

•To use , you must make an connection and an analog audio connection (RCA) between the compo- nent and AV receiver, even if they are connected digi- tally (page 34).

•While Zone 2 is on, the functions do not work.

The AV receiver contains a microcomputer for signal pro- cessing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded cor- rectly.

To reset the AV receiver to its factory defaults, turn it on and, while holding down the [Video 1] button, press the [Standby/On] button. “Clear” will appear on the display and the AV receiver will enter Standby mode.

Set the AV receiver to Standby before disconnecting the power cord from the wall outlet.

86