Integra DTR-5.6 1, 2 1, Changing the Input Display, Minimum Speaker Impedance, Setup closes

DTR-5.6.book Page 42 Thursday, September 22, 2005 5:07 PM

First Time Setup—Continued

Changing the Input Display

If you connect an -capable Integra MiniDisc recorder, CD recorder, or next generation HDD-compat- ible component to the TAPE IN/OUT or VIDEO 3 IN

jacks, for to work properly, you must change this setting.

This setting can only be changed on the AV receiver.

1, 2 1, 2

1	Press the [Tape] or [Video 3]
	input selector button so that
	“TAPE” or “VIDEO3” appears on
	the display.
	or

2	Press and hold down the [Tape]
	or [Video 3] input selector button
	(about 3 seconds) to change the
	setting.
	Repeat this step to select MD, CDR, or
or	HDD.
	For the Tape input selector, the setting
	changes in this order:
		→ TAPE → MD → CDR → HDD
	For the Video 3 input selector, the set-
	ting changes in this order:
		VIDEO 3 ↔ HDD

Note:

HDD can be selected for the Tape input selector or Video 3 input selector, but not both at the same time.

Minimum Speaker Impedance

Not North American models

If you change this setting, you must run the automatic speaker setup again (see page 37).

If the impedance of any speaker is 4 ohms or more but less than 6, set the Minimum Speaker Impedance to 4 ohms.

Note:

Before you change this setting, turn down the volume.

1	Press the [Receiver] button, fol-
	lowed by the [Setup] button.
	The main menu appears onscreen.

2	Use the Up and Down [	]/[	]
	buttons to select “3. Speaker
	Setup,” and then press [Enter].
	The Speaker Setup menu appears.
	3.Speaker Setup
	------------------------
	1.Speaker Impedance
	2.Speaker Configuration
	3.Speaker Distance
	4.Level Calibration
	5.Equalizer Settings
3	Use the Up and Down [	]/[	]
	buttons to select “Speaker
	Impedance,” and then press
	[Enter].
4	Use the Left and Right [	]/[	]
	buttons to select:

4 ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6.

6 ohms: Select if the impedances of all speakers are between 6 and 16 ohms.

5	Press the [Setup] button.
	Setup closes.

Notes:

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

42