DOOR REMOVAL INSTRUCTIONS
NOTE
You will be pulling approximately three feet of water tube from the back of the refrigerator.
4Unscrew the three lower hinge screws and hinge if necessary.
To reinstall the right door, reverse the above steps.
Lower Hinge Removal
Installing Freezer Drawer
1With lower slides pulled out, hang drawer onto slide brackets ensuring pins on each side are fully inserted into slots on each side.
Drawer | Fully Extend |
Assembly | |
| Drawer Slides |
Pin | Cabinet |
| |
| Slot |
2Reinstall four drawer screws (two per side), tighten down, and close drawer (C).
Once both doors are in place, ensure they are aligned with each other and level (Please see the “Installation” section for more details), and replace the top hinge cover.
CAUTION
Be sure doors are set aside in a secure position where they cannot fall and cause personal injury, or damage to the doors or handles.
Removing Freezer Drawer
1Open freezer drawer.
2Remove drawer screws on right and left sides (two screws on each side).
Install Screws |
(2) Each Side |
3 | Check gasket seal around top, bottom, |
| and sides of freezer drawer. |
4 | If gasket is not sealed, open drawer and |
| slightly loosen four drawer screws (two on |
| each side) to allow drawer to rotate. |
5 | Close drawer and recheck the seal on the |
| gasket (A). Open the drawer grabbing by |
| the sides in the center (B). Be careful not |
Remove Hex
Head Drawer
Screw
Do Not Remove |
Other Screws |
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
to rotate the drawer. |
Push | Grab Drawer |
At Center | |
Against | From Both |
Freezer | Sides Then |
Drawer | Pull Drawer |
| Out |
CAUTION
Drawer is heavy. Use caution when lifting.
3 Lift drawer up and out to remove.
A | B |
6Tighten four drawer screws.
7Recheck gasket seal.
8 Install the toe grille by fitting into place.
10
