Frigidaire FGEW2745K F/W/B Electric Cooktop Installation Over, Electric Single Wall Oven Cutout

Electric Cooktop Installation Over 30"/27" Electric Single Wall Oven

For all approved electric cooktop models,

cut minimum 4" x 4" opening in right side filler panel, to route armored cable to junction box

Side filler panels necessary to isolate oven from adjoining cabinets. Panel height may need to be modified to accommodate depth of approved electric cooktop models

Electric Single Wall Oven Cutout

240/208V Junction box for electric cooktop

For all 30"& 27"models †

Approx. 3"

240/208V Junction box for wall oven

Cooktop cutout**

23 1/2 Plywood min.*

base

Approx. 3"

Oven cutout

27 1/4"min.

28 5/8"max.

A

36"

min.

24" min.

cutout depth

4-1/2" maximum height allowed from oven base to floor if cooktop is installed directly over wall oven. (5" maximum height allowed with no cooktop.)

Install 3/4"full plywood base on 2 runners, flush with toe plate, capable of supporting 200 lbs.

Unit will overlap cutout (minimum) edges by 1"			Cutout Width (A)
To route armored cable to junction box,			30" Wall	28 1/2"min.
cut minimum 9" x 9" opening in wood base,			Oven	29"max.
2" from left side filler panel.			27" Wall	24 7/8"min.
			Oven	25 1/4"max.
*Critical dimension – MUST be applied	†
**For cooktop cutout dimensions refer to model-specific		This installation drawing excludes model
product page or installation guide on web		GLEB27Z7H with side-swing door

30"/ 27" Electric Single Wall Oven Under-Counter Installation Specifications

•Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line.

•For detailed electrical requirements, refer to model-specific product page and installation guide on web.

•Always consult local and national electric codes.

•Minimum 21" clearance for oven door depth when open.

•Minimum 23-1/2" deep cutout dimension is critical for proper installation, to ensure that oven’s faceplate will fit flush against cabinet front.

•Side filler panels necessary to isolate oven from adjoining cabinets.

•Full oven base of solid plywood or similar material required, capable of supporting 200 Lbs. (30" models) or 150 Lbs. (27" models). Install over two runners and flush with toe plate.

•Base must be level and cabinet front must be square.

•Allow 5" maximum height from oven base to floor, if NO cooktop is installed directly over wall oven.

Electric Cooktop Installation Over

30"/ 27" Electric Single Wall Oven Specifications

All Frigidaire® Electric Single Wall Ovens are approved to be used beneath any approved Frigidaire® Electric Cooktop. (This installation page excludes approved wall oven model GLEB27Z7H. For model- specific installation details, refer to Electric Cooktop Installation Over 27" Electric Single Wall Oven GLEB27Z7H Specifications pages on web.)

For detailed Electric Cooktop installation, refer to model-specific product page and installation guide on web.

•Side filler panel height may need to be modified to accommodate the depth of approved electric cooktop models.

•To route armored cable to junction box, cut minimum 4" x 4" opening in right side filler panel.

•Allow 4-1/2" maximum height from oven base to floor, if cooktop is installed directly over wall oven.

Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions.

USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com

CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.caSpecifications subject to change.

EC_EW INST FR 02/11 © 2011 Electrolux Home Products, Inc. Printed in the U.S.A.