3.5 cu ft WASHER INSTRUCTIONS (GREEN KIT)

C1) Attaching washer mounting hardware

1.Use the following instructions for mounting either of these types of washers to the pedestal:

2.Attach each front clip to outer-most set of holes with 2 screws and supplied spacer.

Locate spacer under each front bracket.

3.Insert “A” tab of each rear bracket into the middle slots on rear of pedestal. Orient bracket inward for washer mounting.

inward

“A”

middle

tab

 

slot

4.Install 2 screws through each rear bracket into aligning pedestal holes.

D1) Mounting washer

- EXCESSIVE WEIGHT HAZARD - To avoid back or other injury, have more than one person move or lift the washer.

1.Using two or more persons, slightly tip the washer back and lift it onto the pedestal. Still tipped, slide the washer back against the rear brackets and gently set down the front so the appliance is between the front and rear brackets.

SLIDE BACK

TIP DOWN

2.Adjust the appliance side-to-side to align its mounting holes with the pedestal’s bracket holes.

3.Install 2 screws through each rear bracket into the base of the washer.

4.Install a screw through each front bracket into the base of the washer.

E1) Installing or re-installing washer

1.Slide appliance/pedestal into place.

2.Check for levelness and rock all four (4) legs again. Repeat until level and solid.

3.Refer to Washer Installation Instructions for complete details on installing water, drain, or electrical.

• GREEN KIT • GREEN KIT • GREEN KIT • GREEN KIT • GREEN KIT •

3

Page 3
Image 3
Frigidaire 137147600 B (0906), FNDP15B Cu ft Washer Instructions Green KIT, C1 Attaching washer mounting hardware