Structural Back
| Side Panel |
| |
| Front Channel |
| |
| Rear Channel |
| |
| Side Panel |
| |
Front Door | |||
| |||
| Caster Shims | Caster Shims | |
| if required. | ||
Front Channel | if required. | Lock Washer | |
Lock Washer | |||
Front Leg |
| ||
| |||
w/Mounting Plate |
| ||
Screw |
| ||
| Locking Caster | Rear Rigid Caster | |
Adjust as needed. | 13 cm/5 in | 13 cm/5 in |
Leg and Caster Installations
Figure
d.Installing Optional Swivel Casters:
1.Swivel casters can only be used with multiple fryer batteries (two or more fryers battered together).
2.Install
3.Locking casters must be installed at the front of the unit. This allows the fryer to be "locked" in position for safe operations.
4.Follow the same instructions for leg installations as given above in steps
WARNING!
A FRYER MUST BE LEVEL BEFORE FILLING WITH OIL. IF THE FRYER IS NOT LEVEL, THE FRYER MAY TIP OVER AND MAY CAUSE INJURY TO THE OPERATOR.
6
3.3LEVELING:
a.Place a carpenter’s spirit level across the top of the fryer and level the unit both
b.Legs (Only):
1.If the floor is smooth and level, level the unit by using the caster shims. Adjust to the high corner and measure with the spirit level.
2.Adjust leg height with an adjustable or 27mm
3.The hex bullet is for minor leg height adjustment only. Do not adjust more than 22mm (1").