107
6
CAMERA CUSTOMIZING
106
DISCONNECTING FROM THE PC
➀Download “FinePix6800Customizer” software
from “http://home.fujifilm.com/products/digital/”.
➁Install the software in “DSCSETUP” folder in
the “FinePixViewer” folder on your PC.
➂Load a SmartMedia that has available space and
connect the camera (DSC mode) with the PC.
➃Use the FinePixViewer on the PC and transfer
the customizing data to the camera. Disconnect the cradle from the PC and remove
the camera (➡P.106).
➀When you switch the camera on, the
customized screen appears.
➁Press “c” to check the details.
➂Press the “MENU/OK” button to proceed.
1 2
Do not switch the SmartMedia during the
customization procedure. ●
!
If you selected “NO”, the customized screen appears
the next time you switch the camera on.
✽The figure shows
the Macintosh
screen display.
➂Press the “<” (power) button on the cradle
and then disconnect the cradle from the PC.
➃Remove the camera from the cradle.
➄Close the connection socket cover on the
bottom of the camera.
Card reader connection
➀Check that the self-timer lamp is not blinking
(the camera is not communicating with the PC).
➁Follow the correct procedure for your
operating system.
●Windows 98
Check that the power lamp on the cradle is
lit steadily.
●Windows Me/2000 Professional
Click the Eject icon in the taskbar and eject
the media.
●Macintosh
Drag the removable disk drive icon to the
Trash and then check that the power lamp
on the cradle is blinking slowly.
Always follow the procedure below before
disconnecting the camera from your PC.
PC-camera connection
➀Quit “FinePixViewer”.
➁Check that the power lamp on the cradle is lit
steadily.
◆When the Cradle is Not Used ◆
Use the correct procedure for your operating system
and then switch off the camera and disconnect it.
●
!
Check the viewfinder lamp in the camera instead of
the cradle power lamp.
●
!
On a Macintosh computer, check that “REMOVE
OK” is shown on the display panel before removing
the SmartMedia or disconnecting the cable.
●
➀
●
➁
●
➂
●
➃●
➄●
➂