1. Exit any applications that are using the camera (FinePixViewer,
etc.).
2. Check that the camera and Macintosh are
not communicating.
3. Drag the removable disk icon to the Trash.
4. Switch the camera off.
5. Unplug the special USB cable from the
camera.
• Always close all the files in the camera (removable disk) folder and confirm that the
camera and Macintosh are no longer communicating.
• Disconnecting the camera or the USB cable without first dragging the removable disk
icon to the Trash could cause your Macintosh to malfunction.
• When the “Copying” message disappears from your Macintosh screen, wait a few
moments before disconnecting the USB cable or removing the SmartMedia.
If a large amount of data is being copied, camera access continues for a short time
after the message displayed on the Macintosh has gone off.
NOTE
41
This section gives a brief overview of how to use FinePixViewer. Refer to
these instructions while you are using FinePixViewer.
1. Connect the camera to your computer in
DSC mode.
2. When you open the folders shown below in order, the images
in the camera are displayed in the thumbnail display area.
On Windows XP, the removable disk
appears as “FinePix” (for the second
and subsequent connections).
3. Click the [Automatic Taking] button.
NOTE
Mac OS X
Mac OS 8.6–9.2Windows

Saving Images on Your Computer

40
4
qSee “Connection” in
the camera Owner’s
Manual.
Now, you can connect and disconnect the camera in DSC
mode.
Next, proceed to “Using FinePixViewer” on page 41.
See “Connection” in
the camera Owner’s
Manual.
q

Disconnecting the Camera

4Using FinePixViewer
1
2
3
4
qSee “Connection” in
the camera Owner’s
Manual.
1
2
3
1
2
3