6
8382
CONNECTING AT DSC MODE
Camera Operation PC Operation
(USB)
socket
DC IN
5V socket
Camera
USB
socket PC
OFF
ON
101042
03
02
1Load a SmartMedia containing photographed
images into your camera. Plug the AC power
adapter connector into the DC IN 5V socket
on the camera and then plug the adapter
itself into the main power outlet.
2Slide the POWER switch to the side to turn
the camera on.
3Set the “USB MODE” setting in the SET–UP
menu to “DSC” (➡P.78, 79).
4Slide the POWER switch to the side to turn
the camera off.
1Switch your PC on.
2Use the special FinePix F401 USB cable to
connect the camera to your computer.
3Switch the camera on.
Always use the prescribed procedure when
disconnecting or switching off the camera (➡P.86).
If you are using a Windows PC, the driver settings
are specified automatically when installation is
completed. No further action is required.
✽If your PC fails to recognize the camera, refer to
the Software Quick Start Guide.
●
!
On Windows XP and Mac OS X, you must specify the
automatic launch settings the first time you connect the
camera to your computer (➡Software Quick Start Guide
booklet).
●
!
Take care to ensure that the special FinePix F401 USB
cable is connected the correct way around and that the
plugs are pushed fully into the connection sockets.
●
!
Before replacing the SmartMedia, always disconnect
the camera from the PC using the procedure on
P.86.
●
!
Do not disconnect the USB cable when the camera
is communicating with the PC. See P.86 for
information on the disconnection procedure.
iWhen the camera and computer are exchanging
data, the self timer lamp flashes and the
viewfinder lamp flashes alternately green and
orange.
i“DSC” appears on the LCD monitor.
iPower Save is disabled when the camera is
connected to a USB port.
iFinePixViewer automatically starts up.
iA removable disk icon appears and you can
use your PC to transfer files to and from the
camera.
Windows Macintosh
✽
Screen for Windows 98 SE
If the above operations do not occur, you do not
have the required software programs or drivers
installed on your PC. Refer to the Software
Quick Start Guide booklet and complete the
required PC setup procedures. Then reconnect
the camera to your PC.