Use either xD-Picture Card or Microdrive as recording media in the FinePix S7000.
• If an xD-Picture Card and a Mierodrive areinserted at the same time, images will be recorded
onto the media selected as the "MEDIA" (.-P.83).
• Data cannot becopied between the two media types on the FinePix $7000.
Set the Power switch to "OFF", check that the
indicator lamp isoff and then open the slot cover.
:_tOpening the slot cover while thecamera is still turned on, the
camera is turned off.
turned on. This could damage the media or CorruPt
the image files on the media.
..... J
2xD-PictureCard
Gold marking
3
Align the gold marking on the xD-Picture Push the Microdrive firmly all the way into
Card slot with the gold contact area on the Microdrive slot.
the xD-Picture Card and then push the
card firmly all the way into the slot.
Insert only the appropriate media types into the xD-Plcture Card and Microddve slots. Inserting the incorrect media
will damage thecamera or media.
,;t Ifthe media isoriented incorrectly, it will not go all the way into theslot. Donot apply excessive force when inserting
anxD-Plcture Card orMicroddve.
Ifthe media isnot fully inserted into the slot, the "_" message appears.
4
Close the slot cover.
............@How to replace
the xD-Picture Card @
Push the xD-Picture Card into the slot and
then slowly remove your finger. The lock is
released and the xD-Picture Card is pushed
out.
..............@How to replace
the Microdrive @
Open the slot cover, press the Microdrive eject
button and remove the Microdrive.
;,tWhen storing Microdrives, always use the special
protective case provided.
I[H-" I:(_] [4I_ [1111i-"1:11:i:l_V_r_,11_11_[all :y_,_ll i :1:i'4H-" V_,I:[d
Turn the camera on and check that no battery level warning ("C_" or "C::3") appears on the
screen. If no icon appears, there is ample charge left in the batteries.
1_ No icon
(_ _ Litred
C_] Blinking red
(!) There is ample remaining battery charge.
(_ There is insufficient charge left in the batteries.
The batteries will soon run out. Have anew set
of batteries ready.
_3")The batteries are depleted. The display will
shortly go blank and the camera will stop
working. Replace or recharge the batteries.
"tE::_" appears as a small icon on the right-hand
side of the screen. "C:3" appears as a large icon
on the screen.
PThe information above isan approximate guide for photography mode. Depending on the camera mode and the type
of batteries used, thetransition from "(:11_" to "C:]" may occur more quickly.
_;tWhen thebatteries run out, "C:]" appears and camera operation automatically stops. When this occurs, the camera
may work if you turn it on again even without loading new or fully charged batteries. However, this may cause
camera faults such as the camera turning itself off without retracting the lens. Always load new orfully charged
batteries.
;t Due to the nature ofthe battery, the battery low warning may appear early when the camera is used incold
locations. Thisis normal and does not indicate a fault. Try warming the batteries inyour pocket or a similar location
before use.
...........<_.Power save function @ ........._
When this function is active, it alsoturns off the screen (Sleep mode) to reduce power consumption if
the camera is not used for 30 seconds (-_P.86). If the camera is then left unused for 2 or 5minutes, the
Power save function automatically turns the camera off. To turn the camera back on, set the Power
switch to "OFF" briefly and then back to"1_1"or "i_".
..... J