Manuals / Fujitsu / Computer Equipment / Scanner

Fujitsu 15C user manual Connecting the Cable i. Turning the Power Off, ii. Turning the Power On

Models: 15C

1 23

Download 23 pages 2 Kb

Page 13

2.7Connecting the Cable

2.7Connecting the Cable

i). Turning the Power Off

Depress the side marked “O” to turn the power off.

Connect the power cable and SCSI signal cable as shown in Figure 2-8.

ii). Turning the Power On

Depress the side marked “I” to turn the power on. The POWER LED will light. If not, please check the power source.

iii). SCSI Termination

The Fujitsu Scanpartner 15C comes complete with a built in SCSI terminator. If the Scanner is the last device in a SCSI chain the terminator should be switched on. If the Scanner is not the last device the terminator should be off. The terminator on/off switch is located on the back of the Scanner, to the left of the SCSI cable connectors.

Host PC

Term.

Scanner

SCSI Device

Term.

(Terminator Off)

Host PC

Term.

Scanner

(Terminator On)

2-9

Image 13

Fujitsu 15C user manual Connecting the Cable i. Turning the Power Off, ii. Turning the Power On, iii. SCSI Termination

Contents

Image Scanner Scanpartner 15CTable of Contents 1. INTRODUCTION Output Paper Rack Figure 1-1 Scanner packingPrecautions 2. INSTALLATION AND CONNECTIONS2.1 Shipping Bracket 2.1.1 Removing the Shipping Bracket refer to figures 2-1 andFigure 2-2 Securing the Shipping Bracket Figure 2-1 Removing the Shipping Bracket2.2 SCSI Interface Device ID 2.1.2 Refitting the Shipping BracketSCSI ID Selector Figure 2-3 Adjusting the SCSI ID setting2.3 ADF Paper Chute Figure ADF Output Tray Figure Figure 2-5 Install the ADF Output Paper TrayHold the output paper rack some 30 degrees aslant as shown in Figure For flatbed scanning 2.5 Document Loadingi. Place the document to be scanned onto the document glass face down Figure 2-6- Place Document on the Scanner2.6 ADF Scanning ii. Turning the Power On 2.7 Connecting the Cable i. Turning the Power Offiii. SCSI Termination Figure 2-9 Scanpartner 15C SCSI Scanner Cable Connections with Mac Figure 2-8 Scanpartner 15C Scanner Cable ConnectionSCSI Cable 3.1 Cleaning the ADF 3. MAINTENANCEFigure 3-1 Opening the ADF unit and Document Cover Figure 3-2 The Cleaning Area 3.2 Cleaning the Glass The proceduresi. Soak a cotton swab with some isoprophy alcohol 95% 4.1 Question and Answer 4. TROUBLESHOOTINGQuestion Paper becomes skewed in the Scanner 4.2 Paper Jam in the ADF Figure 4.2 ADF Paper Jam - Removing the Paper All specifications are subject to change without notice 5. SPECIFICATIONSThe following can not be properly fed by ADF 5.1 Scanpartner 15C Specifications