Fujitsu AH512, A512 Error messages on the screen, Troubleshooting and tips, Error message/cause

Troubleshooting and tips

Error messages on the screen

This section describes the error messages generated by the BIOS Setup. Error messages displayed by the operating system or programmes are described in the relevant documentation.

If the error message appears repeatedly, despite troubleshooting measures, please contact the place of purchase or our customer service centre.

Error message/cause	Resolution
CMOS battery bad	► Contact your sales outlet or our customer
If the error message occurs repeatedly, the	service centre.
buffer battery in the notebook is flat.
System CMOS checksum bad - default configuration	► Switch the notebook off.
used	► Switch the notebook on.
The system configuration information is	► Press the function key				to access the
				F2
incorrect.	BIOS Setup.
	► In the BIOS Setup, select the Exit menu.
	► Select the entry Load Setup Defaults.
	► Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:	► Check whether the additional memory
zzzz zzzz	module has been inserted correctly.
When testing the extended memory an error has
resulted at the address xxxx.
Failure Fixed Disk n	► Start the BIOS Setup (Primary Master
The settings of the hard disk drive are incorrect.	submenu) and select the correct settings.
Keyboard controller error	► Switch the notebook off with the ON/OFF
	switch.
	► Wait 3 - 5 seconds and switch on the
	notebook again.
Keyboard error	If you are using an external keyboard:
	► Check the connection and reboot the
	notebook.
nn Stuck key	► Make sure that no key is pressed.
Operating system not found	► Check in the BIOS Setup whether your hard
	disk has been set correctly.
	► Make sure that the operating system is
	installed on the corresponding drive.
Press <F1> to resume, <F2> to SETUP	► Press the		function key to start the
		F1
This error message appears if an error occurs	operating	system.
	► Press the function key				to access the
during the self-test before starting the operating				F2
system.	BIOS Setup.

64 Fujitsu