Fujitsu C122-E180-01EN 1.2.2 Installing the REMCS function , 1.2.3 Connection configurations supported by the REMCS function

CHAPTER 1 REMCS Service Overview

1.2 REMCS Linkage Overview

C122-E180-01EN

Collects hardware configuration information of the entire server, monitors the server for problems, and

reports thereon to the REMCS Center.

- SVS

Collects configuration information of the PCI cards and SCSI devices recognized in the partition and

monitors them for problems.

Detects changes in the hardware or software configuration, and reports the latest configuration information to

the REMCS Center.

When a hardware problem occurs in a server, automatically notifies the REMCS Center of the problem and

sends problem information including logs to the REMCS Center.

Whenever an event involving a hardware problem occurs in the same unit after the REMCS Center has been

notified of the hardware problem, notification thereon to the REMCS Center is suppressed. Events detected

by SVS are cleared when the operating system is rebooted or when SVS is stopped or restarted. When a

problem with a notification level that is higher than that of an event for which notification is being suppressed

occurs in the same part, problem notification takes place even within the notification suppression period. At

this time, the notification suppression time is cleared to 0, and the notification suppres sion cont inue s. For

SVS, there is no processing related to notification suppression time. Accordingly, until a problem with a high

notification level occurs or until the events are cleared, notification of abnormalities is suppressed.

Automatically connects to the REMCS Center at specified times to confirm the existence of the

communication path and REMCS Agent

1.2.2 Installing the REMCS function

The REMCS function of the PRIMEQUEST 2000 Series consists of the MMB and SVS installed on the

partition side.

The MMB REMCS function is installed as standard. The function does not need to be installed.

For details on the procedure for installing the function in SVS, see 5.2 Setting of SVS (SVagent) in the

PRIMEQUEST 2000 Series Installation Manual (C122-E174EN).

1.2.3 Connection configurations supported by the REMCS function

The PRIMEQUEST 2000 Series supports only the connection configurations shown below. Each of these

connection configurations uses only SMTP for communication with the REMCS Center.

- Internet connection (e-mail)

With this connection configuration, communication with the REMCS Center is executed via the Internet.

- P-P connection (ISDN: e-mail)

With this connection configuration, communication with the REMCS Center is executed with a P-P

system using a line such an ISDN line.