Fujitsu FP-410 user manual Appendix C Special Modes, Test Printing

Appendix C: Special Modes

C-1. Test Printing

Turn off the printer power switch, put the paper in place, and turn on the printer power switch while holding down the FEED switch on the control panel. The data below is printed. When "Test print" is printed, press the FEED switch for about two seconds to start the test printing.

After a fixed amount of data is printed, the paper is automatically cut and the test printing terminates.

TEST PRINT

END

SET UP

HEX DUMP

TEST PRINT

SELECTION ITEM

ITEM SELECTION: FEED SW IS PUSHED SHORT

ITEM SELECTION: FEED SW IS PUSHED LONG

Example of contents of test printing

Firmware Number KA02001-J005

Firmware Version 01A (018701)

POWER ON STATUS	DISABLE
RECEIVE BUFFER	4K BYTE
BUSYCONDITION	OFFLINE/BUFFERFULL
RECEIVE ERROR	?PRINT
AUTO LF	DISABLE
	•
	•

53