DIP Switch Settings
The factory default settings are as follows: 1 2 3 4 5 6 7 8
ON
OFF
DIP Switch Functions
(*Note: the 
indicates the switch position)
SW | Function | ON state / OFF state |
| |
1 | Hot Key Mode: <Ctrl>+<Alt>+<Shift> | ON: enabled / OFF: disabled | ||
2 | Hot Key Mode: Double <Ctrl> | ON: enabled / OFF: disabled | ||
3 | Hot Key Mode: Double <Scroll Lock> | ON: enabled / OFF: disabled | ||
4 | Country Setting bit 1 | (see following table) |
| |
5 | Country Setting bit 2 | ( | “ | ) |
6 | Country Setting bit 3 | ( | “ | ) |
7 | Country Setting bit 4 | ( | “ | ) |
8 | Power Mode Setting | ON: | the switch device is always ON. | |
|
| OFF: | the switch device turns ON if any connected host | |
|
|
| is turned ON. |
|
The country code (language) settings are as follows:
Country Setting | SW4 | SW5 | SW6 | SW7 |
Japan | ON | ON | ON | ON |
US | ON | ON | ON | OFF |
UK | ON | ON | OFF | ON |
German | ON | ON | OFF | OFF |
French | ON | OFF | ON | ON |
Spanish | ON | OFF | ON | OFF |
Swedish | ON | OFF | OFF | ON |
Switching the KVM While Using SUN Hosts
When using only Sun hosts, you can change KVM switches without turning off the power to a Sun host. Disconnect the connector from the KVM side only when changing them. Leave the host side connectors attached.
Note: When using PC/AT hosts, if all connections are USB type, you can similarly change KVM switches without turning off the power to the hosts.
8
