English

• Minimizing phosphor burn-in (Screen Orbiter)

for RGB

You can use this option to move the screen position to minimize phosphor-induced “burn-in”.

Follow the steps below.

(1) Select “Screen Orbiter” and press .

The “Screen Orbiter” setting screen will appear.

(2) Press or to select “Mode/Time”.

(3) Select a desired pattern.

Each time you press or , one of the available choices appears in the following sequence:

“Screen Orbiter” setting screen

 

Off: Disables Screen Orbiter.

Time: Moves the pattern approximately every one hour.

Mode: Moves the pattern when the power is turned ON or when you switch between modes.

(4) Press or to select “Moving Area”.

(5) Press or to select the range for moving the pattern.

Each time you press or , one of the available choices appears in the following sequence:

Min.: Pattern moves in small range. (About 5 pixels)

Std.: Pattern moves in moderate range. (About 10 pixels)

Max.: Pattern moves in wide range. (About 15 pixels)

(6) Press to store.

Using screen protection functions (examples)

The screen protection functions minimize phosphor burn-in but cannot completely eliminate it.

When using the display occasionally

When using the display continuously

 

 

• Select a desired amount of time for “DPMS”.

When switching between RGB and video input modes only

Thus, when the display does not receive a signal, it will automatically

occasionally

display white or black over the entire screen. When the predetermined

(1)

Select “Time” for “Mode/Time” with “Screen Orbiter”.

time elapses, the power will turn OFF.

(2)

Select a desired range for “Moving Area” with “Screen Orbiter”.

 

 

This causes the screen saver pattern to move in the same range at

 

 

regular intervals.

 

When switching between RGB and video input modes

 

frequently

 

(1)

Select “Mode” for “Mode/Time” with “Screen Orbiter”.

 

(2)

Select a desired range for “Moving Area” with “Screen Orbiter”.

 

 

When the mode is switched from Video to RGB, the display position

 

 

moves.

 

 

 

•Input mode of priority (Input Priority)

You can use this option to switch between modes only when a signal is received through the selected input mode terminal. You cannot switch the input mode.

Each time you press or , one of the available choices appears in the following sequence:

Off: Switches between modes normally.

Other modes: Displays pictures when a signal is received through the selected input mode terminal.

Press to store.

* On-screen information disappears if you do not take any action for about 60 seconds.

E-31