Fujitsu PDS4203W-H / PDS4203E-H Care And Maintenance, Before Cleaning, Before Requesting Repair

CARE AND MAINTENANCE

BEFORE CLEANING

Always unplug the power cord from the

socket.

Cleaning the cabinet and remote controller

Do not use benzene, paint thinner, or other solvents. They can cause deterioration or paint peeling on the cabinet, the screen front filter, or the remote controller.

Wipe gently with a soft cloth.

For stubborn grime, soak the soft cloth in neutral cleaning agent diluted with water, wring it out well, and wipe clean. Then, finish with a dry, soft cloth.

Cleaning the screen

Wipe gently with a soft cloth.

The surface of the screen is easily scratched, so do not strike it or rub it with anything hard.

BEFORE REQUESTING REPAIR

If you think a malfunction may have occurred, check the following items.

When this happens	Check
• The power does not come on.	• Is the power cord disconnected?
• The picture dose not appear.	• Is a cable to other equipment disconnected?
• The remote controller does not work.	• Are the batteries installed with their poles reversed?
	• Are the batteries flat?
	• Are you operating from far away?
	• Are you trying to operate with the transmitting section of the
	remote controller not facing the reception section of the
	display?
	• Is there any obstruction between the display and the remote
	controller?
• There is a creaking sound.	• This sound is generated by the expansion and contraction of
	the cabinet owing to change in the room temperature.
• There is a humming sound.	• The Plasmavision has heat radiation fins to prevent its internal
	temperature from rising too high during operation. The sound
	you hear is the fan rotating.
• There are dots on the screen.	• Is the connected tuner being affected by interference from a
	car, train, high-voltage line, neon light, or the like?
• The colors and tints are not good.	• Do any of the video settings need readjusting?
• There is no sound.	• Are the internal speakers switched off?
• ERROR MESSAGE CONDITION 1 is displayed.	• The fan is malfunctioning. Switch off the power.
• ERROR MESSAGE CONDITION 2 is displayed.	• The temperature inside the set has risen far too high.
	Switch off the power. (The power can be turned on once the
	temperature lowers.)

4 4