The following shows how to configure a LiveLink.
1
2Check the "Enable LiveLink" box.
It is recommended to accept the default values for "Probe interval" (the number of seconds between each retransmission of a link packet to the probe target) and "Probe maximum retries" (the number of consecutively missed responses from a probe target before a failover is triggered).
To specify different values, click the desired probe interval in the "Probe interval (seconds)" list and click the desired maximum number of probe retries in the "Probe maximum retries" list.
3Click the probe target at the top of the list, click "Edit Target IP Address", type the target IP address for one or all probe targets in the "IP Address" box, and then click [OK].
`Only the first probe target is required. You can specify up to 3 additional probe targets to serve as backups by assigning IP addresses to the other probe targets.
