Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2AIR CLEANER RESET / MANUAL AUTO button
●Intake grill opening mechanism.
When the remote control is not available for use, this button can be used as a
3Indicator Lamps (Fig. 3)
4Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
●If the TIMER indicator lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See Page G Auto Restart).
7AIR CLEAN Indicator Lamp (green)
8 SWING Indicator Lamp (orange)
9Intake Grille (Fig. 4)
0 Air Filter
A Air Flow Direction Louver B
(behind Air Flow Direction Louver) C Drain Hose
D Electrical Air Cleaning Filter
Fig. 5 Outdoor Unit
EIntake Port F Outlet Port G Pipe Unit
●Refer to the folded out page on the cover.
Fig. 6 Remote Control Unit
HMASTER CONTROL button
ISET TEMP. / SET TIME buttons
K TIMER button
L FAN CONTROL button M START/STOP button N AIR CLEAN button O SET button
P SWING button Q ACL button
R TIME ADJUST button
Rear side (Fig. 7)
STEST RUN
●Touch the two metal contacts with a metallic object to send the signal to perform a test run.
●Perform a test run only when installing the air conditioner. If the signal to perform a test run is received during normal operation, the air conditioner’s thermostat will malfunction.
●If the signal to perform a test run is re- ceived during normal operation, the unit will switch to the test operation mode and the indoor unit’s OPERATION and TIMER indicator lamps will flash simultaneously.
●To stop the test operation mode, press the START/STOP button to stop the air conditioner.
TRemote Control Unit Display (Fig. 8) U Transmit Indicator
V Clock Display
W Operating Mode Display X T imer Mode Display Y Fan Speed Display
Z Temperature Set Display [ Timer Set Indicator
\ Temperature Set Indicator
